![]() ![]() Very very viable options as appliances, cheap as shit too. ![]() They will be super powered for what they are doing, and far far more affordable (64 bit, low clock, low power risc with flash storage? Total cost of a kitted machine alone with the data cards will be at most 80 bucks and some time). ![]() Even for the agp models these upgrades on the fw can enable a LOT of features, and I’m thinking about picking up 1.6 and 1.8 GHz machines and stuffing them full of data cards and ssd’s on the pci slots, then setting them up with void Linux and selling them as storage servers. When you go on YT and look at G5 overviews they are looking at it from a nostalgic point of view, not from a ppc enthusiast point of view. And often you can find a G5 2.3, 2.5, or 2.7 dual core without the fw updates. From a security and stability standpoint, this was key for a lot of corps and schools.Įnd users, however, almost never did these updates. This was a big deal for businesses as often it enabled some stuff for gpu’s, enabled new storage options, and more commands to configure hardware or disable it completely. You had to do it by hand, and if you signed up for email updates back in the day you would often be notified that new ofw was out. Note to most people doing this, or wanting to, fw updates were rarely done by end users and didn’t come down the update streams. You might find this site to be interesting.Also im stupid lucky that the mac g5 was not updated on its firmware or i would not have been able to do this Again, your hardware isn't old enough to limit your options, and almost all of the mainstream Linux distributions (and some of the not-quite-so-mainstream distributions, as well) have been ported to PowerPC. If you're sure that you want to run a Linux distro, you truly have countless options. Apple's Safari (included with OS X be sure to download the latest version) is an incredible browser on the Mac (less so on Windows), or you can run Firefox, Opera, OmniWeb, Chrome, etc. Your machine is not old enough that you're consigned to running a Linux distro on it just to make it barely usable on the Web. Running OS X also solves the problem of modern browsers not being available that you would otherwise face by sticking with Mac OS 9. My not-so-humble opinion is that Mac OS X absolutely blows away any Linux distribution, even for the hardest core UNIX fans, considering it runs on top of a BSD UNIX-based kernel. I highly recommend this route if you/your friend is not already an experienced Linux user one of the major appeals of the Mac platform is the operating system. Pick up as much as you can afford, and cram it in. Chances are very good that your machine uses the old standard PC100/PC133 168-pin SDRAM, which is available for extremely reasonable prices nowadays. ![]() Make sure that you have at least 512 MB, preferably 1 GB. Remember that RAM (not processor speed) is key to making Mac OS X run at peak performance. Otherwise, you can install a full retail copy on a G4/1GHz without any extra effort. If your machine is one with a third-party G3 upgrade card, you may need to hack the newer versions of OS X to run them, but this is a relatively straightforward process, and you won't have any performance problems once you get it installed. My home network server is a 733 MHz G4 running OS X 10.4 (Tiger) Server (and I'm hardly your "average" home network user). My mother uses a 933 MHz G4 running OS X 10.5 (Leopard) all day long to surf the web and do other basic computing tasks it's never been slow. In either case, the machine can quite comfortably run an older version of Mac OS X that supports PPC processors (at the time of this writing, all that leaves out is the latest release, OS X 10.6 Snow Leopard, which drops support for the PPC platform altogether in favor of Intel). A PowerPC Mac with a 1 GHz processor either has a factory-installed G4 processor or has a G3 upgrade card installed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |